Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:genmsr04 [2020/10/29 22:03] hippysmack [Using / Diagnosing with a Slack Tube (Manometer)] |
techtalk:ref:genmsr04 [2020/10/30 00:30] hippysmack [Modified Oil Tank Cap] |
||
|---|---|---|---|
| Line 74: | Line 74: | ||
| ==== Modified Oil Tank Cap ==== | ==== Modified Oil Tank Cap ==== | ||
| + | You can drill a hole for an NPT fitting in a spare oil cap or make a cap just for testing. \\ | ||
| + | The one below was made from a rubber plug bought at Lowes. [[techtalk:ref:genmsr04a|Click here]] to see the pics of the mod. \\ | ||
| + | |||
| + | {{:techtalk:ref:genmsr:homemade_test_oil_cap_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| + | |||
| + | If you're testing the 04-up plastic oil tank for high pressure, the oil cap is not going to be helpful as a test point. \\ | ||
| + | You need a tee installed in the vent line for that. \\ | ||
| ====== Testing crankcase pressure ====== | ====== Testing crankcase pressure ====== | ||
