Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ref:engmech01q [2019/02/18 05:21] hippysmack [Aftermarket Lifters] |
techtalk:ref:engmech01q [2024/01/14 18:24] hippysmack |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ====== Tappet Flats ====== | ====== Tappet Flats ====== | ||
| **This is in consideration of induced noise from the use of high lift cams**. \\ | **This is in consideration of induced noise from the use of high lift cams**. \\ | ||
| - | The factory lifter is up to the job from the point of view of the hydraulics. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1510606&page=2)) \\ | + | The factory lifter is up to the job from the point of view of the hydraulics. ((aswracing of the XLFORUM https://www.xlforum.net/forum/vendors/hammer-performance/139198-well-been-doing-some-thinking-excess-valvetrain-noise/page2?t=1510606&page=2)) \\ |
| However, the factory lifter's weaknesses are lack of available travel and less durable axle bearings. \\ | However, the factory lifter's weaknesses are lack of available travel and less durable axle bearings. \\ | ||
| It's possible to machine the flat longer on a stock lifter. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=341901)) \\ | It's possible to machine the flat longer on a stock lifter. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=341901)) \\ | ||
| Line 88: | Line 88: | ||
| The longer flats also allow higher lifts. | The longer flats also allow higher lifts. | ||
| - | It seems aftermarket lifters have a tendency to be wide at the roller end. \\ | + | |
| - | Measure them before installing to be sure they won't scratch the lifter bore when turned home. ((Hippysmack of the XLFORUM )) \\ | + | |
| - | + | ||
| ===== Other Useful Links ===== | ===== Other Useful Links ===== | ||
| This is a very good XLFORUM discussion thread on [[http://xlforum.net/forums/showthread.php?t=1933342&highlight=disassembling+lifters|lifters and high lift cams]]. \\ | This is a very good XLFORUM discussion thread on [[http://xlforum.net/forums/showthread.php?t=1933342&highlight=disassembling+lifters|lifters and high lift cams]]. \\ | ||
| ===== Feuling lifters ===== | ===== Feuling lifters ===== | ||
| + | |||
| + | |||
| + | |||
| ===== Gaterman Lifters ===== | ===== Gaterman Lifters ===== | ||
| Four different models are available for XL's. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?s=73d24db8f0756ef41c6215fd92ad0055&p=4726240)) \\ | Four different models are available for XL's. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?s=73d24db8f0756ef41c6215fd92ad0055&p=4726240)) \\ | ||
