Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ih:oil03p [2021/11/11 21:15]
hippysmack [Gerotor shear pins]
techtalk:ih:oil03p [2021/11/11 21:26]
hippysmack [Inspect both gerotor sets]
Line 178: Line 178:
 **Check inner to outer gerotor clearance on each gerotor set**. \\ **Check inner to outer gerotor clearance on each gerotor set**. \\
 Each gerotor set is made with an inner and outer piece. Mesh the two pieces together (as they normally would sit in operation). \\ Each gerotor set is made with an inner and outer piece. Mesh the two pieces together (as they normally would sit in operation). \\
 +This clearance has a direct relationship to oil pump flow and oil pressure. \\
 +The wider the clearance the more the gerotors lose their ability to hold enough pressure to the outlet cavity. \\
 +They also the ability to transfer oil from the feed cavity back to the inlet cavity and recirculate oil within the oil pump. \\
 +
   * Arrange so there is 1 inner tooth facing the center of the wide outer radius. \\ Use a feeler gauge between the inner tooth and outer radius there for a maximum of .004" clearance between them. \\ If the clearance is larger than .004", replace the affected gearotor set. Repeat for the other gerotor set.    * Arrange so there is 1 inner tooth facing the center of the wide outer radius. \\ Use a feeler gauge between the inner tooth and outer radius there for a maximum of .004" clearance between them. \\ If the clearance is larger than .004", replace the affected gearotor set. Repeat for the other gerotor set. 
  
 {{:​techtalk:​ih:​oil:​1977-1985_oil_pump_gerotors_-_checking_clearance_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) \\ {{:​techtalk:​ih:​oil:​1977-1985_oil_pump_gerotors_-_checking_clearance_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) \\
 +
 \\ \\