Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:oil03 [2023/07/20 21:46] hippysmack [Leaky gaskets and hose connections] |
techtalk:evo:oil03 [2023/07/21 01:52] hippysmack [Priming the Oil Pump] |
||
---|---|---|---|
Line 153: | Line 153: | ||
* If you let it sit long enough, oil will gravity drain inside the pump and prime it. | * If you let it sit long enough, oil will gravity drain inside the pump and prime it. | ||
* Another way to prime the pump is to use assembly lube on the gerotors and inside of the pump before installing it. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?p=4805186#post4805186)) \\ Then you have an instant hydraulic seal to help the oil pump suck oil from the hose. | * Another way to prime the pump is to use assembly lube on the gerotors and inside of the pump before installing it. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?p=4805186#post4805186)) \\ Then you have an instant hydraulic seal to help the oil pump suck oil from the hose. | ||
- | * You can also using a large syringe with a tapered tip inserted into the oil supply hose on the bottom of the oil tank. ((ericfreeman of the XLFORUM http://xlforum.net/forums/showthread.php?p=5751479#post5751479)) \\ Then you can force feed oil the pump and on to the engine using this technique and it avoids having to mess with the sending unit. | + | * You can also using a large syringe with a tapered tip inserted into the oil supply hose on the bottom of the oil tank. ((ericfreeman of the XLFORUM http://xlforum.net/forums/showthread.php?p=5751479#post5751479)) \\ Then you can force feed oil to the pump and on to the engine using this technique. |
\\ | \\ | ||
====== Oil Pump - Complete Unit Part Numbers ====== | ====== Oil Pump - Complete Unit Part Numbers ====== | ||
Line 226: | Line 226: | ||
===== Leaky gaskets and hose connections ===== | ===== Leaky gaskets and hose connections ===== | ||
+ | ==== Internal leaks ==== | ||
+ | Generally, oil will leak into the motor on shutdown (especially on extended shutdown periods). \\ | ||
+ | For more information on that, [[techtalk:ref:oil10|Click Here]] to view "Sit Sumping" in the REF section of the Sportsterpedia. \\ | ||
+ | |||
+ | Below is concerning an issue with gaskets or seals where either oil / air or both leak into the motor while riding. \\ | ||
+ | |||
{{:techtalk:ih:oil:1977-up_sportster_oil_pump_internal_gasket_leak_by_hippysmack.gif?direct|}} | {{:techtalk:ih:oil:1977-up_sportster_oil_pump_internal_gasket_leak_by_hippysmack.gif?direct|}} | ||