Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:tools101 [2018/09/19 16:03] hippysmack [Storing Bolts] |
techtalk:ref:tools101 [2022/03/23 21:14] (current) hippysmack |
||
---|---|---|---|
Line 25: | Line 25: | ||
- | ====== Primary and Cam / Gearcase Cover Removal ====== | + | ====== Primary and Cam / Gearcase Cover ====== |
- | ===== Storing Bolts ===== | + | Early primary and cam covers had flat head, phillips and posidrive heads. \\ |
- | Some bolts are longer than the others. \\ | + | It's difficult to get them tight enough to keep from leaking and easy to get them too, causing leaks, case cracks or broken screws. \\ |
- | So you'll need to keep them in order of removal for an easier time of re-installing them. \\ | + | This prompts some to change the screws out to modern hex (allen) head socket screws. \\ |
- | You can use a piece of cardboard or an old pizza box to keep from mixing up the primary cover screws (or cam cover). | + | Even allen head screws won't take a lot of over-torque without distorting the drive slots in the head though. \\ |
+ | For the most even tightening of any of these screws, you can use a torque wrench with the correct bits. \\ | ||
- | * Make an outline on the cardboard using the new gasket or even the cover itself and poke the holes for the screws with a punch or Phillips screwdriver. | + | You can find hex bits at hardware / tool stores that are either made to socket wrench adapters or made to insert into them. \\ |
- | * Keeping the bolts in order as you take them off saves time and headache of remembering which length goes where. | + | Then simply attach the adapter to a torque wrench and torque away. \\ |
+ | With the cover screws only being spec'd at 80-110 in/lbs, an in/lb beam torque wrench will give more consistent results than an in/lb clicker wrench. \\ | ||
+ | The pic below shows a 0-80 in/lb torque wrench with adapters for a flat head screw. Just use the correct hex bit needed. \\ | ||
- | |{{:techtalk:ref:tools:primary_cover_screw_holder_by_luxblue.jpg?direct&300|}}| {{:techtalk:ref:tools:gearcase_screw_holder_by_johnny_wolf.jpg?direct&300|}}| | + | {{:techtalk:ref:tools:torque_wrench_with_hex_bit_adapters_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
- | ^ Protecting / retaining primary cover ((photo by luxblue of the XLFORUM http://xlforum.net/forums/showthread.php?t=1098213&highlight=oil+pump+spacer)) and Gearcase Cover ((photo by Johnny Wolf of the XLFORUM)) Screws ^^ | + | |
===== Primary Cover ===== | ===== Primary Cover ===== | ||
- | + | \\ | |
- | + | ||
===== Cam / Gearcase Cover ===== | ===== Cam / Gearcase Cover ===== | ||