Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:svcproc11i [2021/08/28 01:20] hippysmack [Threading the end of the shift drum for a nut] |
techtalk:ref:svcproc11i [2021/08/28 01:21] hippysmack [Threading the end of the shift drum for a nut] |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| ===== Threading the end of the shift drum for a nut ===== | ===== Threading the end of the shift drum for a nut ===== | ||
| **Warning**: This mod is irreversible. You can not go back to the stock flex clip after performing this mod. \\ | **Warning**: This mod is irreversible. You can not go back to the stock flex clip after performing this mod. \\ | ||
| + | If you change your mind later or the shaft/threads get messed up, you'll need to replace the entire drum. \\ | ||
| It is possible to grind the shaft end (where the retainer ring groove is) down to the correct size to cut threads with a die for a nut. \\ | It is possible to grind the shaft end (where the retainer ring groove is) down to the correct size to cut threads with a die for a nut. \\ | ||
