Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech05k [2021/07/26 05:21] hippysmack [Installing "Slobber Stoppers" (1991-1993 Models)] |
techtalk:ref:engmech05k [2021/07/26 05:24] hippysmack [Install the Rocker Boxes] |
||
|---|---|---|---|
| Line 164: | Line 164: | ||
| ===== Install the Rocker Boxes ===== | ===== Install the Rocker Boxes ===== | ||
| Before installing the rocker boxes back on the motor, make sure they are clean from all dirt, debris, shavings etc. \\ | Before installing the rocker boxes back on the motor, make sure they are clean from all dirt, debris, shavings etc. \\ | ||
| - | It won't hurt to spray them down with carb cleaner etc. before installing the umbrellas. The instructions say to install new umbrellas. \\ | + | It won't hurt to spray them down with carb cleaner etc. before installing the umbrellas. The instructions say to install new umbrellas anyway. \\ |
| Make sure both the umbrellas and their now counterpart Slobber Stoppers goes on the intake side on each cylinder. \\ | Make sure both the umbrellas and their now counterpart Slobber Stoppers goes on the intake side on each cylinder. \\ | ||
| Visually inspect that either gasket does not pinch or pooch out after you tighten up the cover bolts. \\ | Visually inspect that either gasket does not pinch or pooch out after you tighten up the cover bolts. \\ | ||
