Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
techtalk:ref:engmech05g [2019/07/17 05:30] hippysmack [REF: Oiling & Lubrication - Sub-05G] |
techtalk:ref:engmech05g [2023/12/21 21:30] hippysmack |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== REF: Engine Mechanicals - Sub-05G ====== | ====== REF: Engine Mechanicals - Sub-05G ====== | ||
====== 86-90 Engine Breather Mod Using #4 Cam as an Oil Slinger ====== | ====== 86-90 Engine Breather Mod Using #4 Cam as an Oil Slinger ====== | ||
- | Article by norseXL of the XLFORUM ((http://xlforum.net/forums/showthread.php?t=1930406&highlight=reed+valve)) \\ | + | Article by norseXL of the XLFORUM ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-bottom-end/179674-breathing-thru-the-cam?t=1930406&highlight=reed+valve)) \\ |
This is an idea based from the breathing on the BMW Rotax twins. \\ | This is an idea based from the breathing on the BMW Rotax twins. \\ | ||
Line 20: | Line 20: | ||
In drilling the hole in the cam: \\ | In drilling the hole in the cam: \\ | ||
- | The chances of either carbide or HSS drills working well are not high. ((Ireeman of the XLFORUM http://xlforum.net/forums/showthread.php?t=1930406&highlight=reed+valve&page=3)) \\ | + | The chances of either carbide or HSS drills working well are not high. ((Ireeman of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-bottom-end/179674-breathing-thru-the-cam/page3?t=1930406&highlight=reed+valve&page=3)) \\ |
They tend to walk over the required distance. A gun drill is good or EDM is best for this process. \\ | They tend to walk over the required distance. A gun drill is good or EDM is best for this process. \\ | ||
You do not want to change to properties of the case hardening (which conventional even with coolant, drilling would do). \\ | You do not want to change to properties of the case hardening (which conventional even with coolant, drilling would do). \\ |