Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:engmech04m [2022/01/03 23:43] hippysmack [Why Oil Pukes Out the Breather or Air Cleaner] |
techtalk:ref:engmech04m [2022/01/03 23:46] hippysmack [Things you can try to reduce oil carryover] |
||
|---|---|---|---|
| Line 57: | Line 57: | ||
| ====== Things you can try to reduce oil carryover ====== | ====== Things you can try to reduce oil carryover ====== | ||
| - | - Check to make sure you haven't overfilled the oil tank. \\ Topping off the oil tank on a cold engine is a common mistake. | + | - Check to make sure you haven't overfilled the oil tank. Topping off the oil tank on a cold engine is a common mistake. \\ Also in regard to lowering the oil level in the oil tank: |
| * 1957-2003 oil tanks are metal. | * 1957-2003 oil tanks are metal. | ||
| - | * They have plenty of unrestricted air inside and do not require one to lower the oil level to the low mark on the dipstick. | + | * They have plenty of unrestricted air inside and do not require one to lower the oil level to the low mark on the dipstick. |
| - | * 2004-Up oil tanks are plastic. \\ They are poorly designed in general to handle what they are asked to do. \\ There is an excepted practice of lowering the oil to the bottom dipstick mark on 2004-up Sportsters. \\ This is sort of a band-aid to the real issue being oil tank construction, but reportedly does work to keep down excess oil out the breathers. | + | * 2004-Up oil tanks are plastic. |
| + | * They are poorly designed in general to handle what they are asked to do. \\ There is an excepted practice of lowering the oil to the bottom dipstick mark on 2004-up Sportsters. \\ This is sort of a band-aid to the real issue being oil tank construction, but reportedly does work to keep down excess oil out the breathers. | ||
| - Check for oil seepage around gaskets. \\ The crankcase should only allow oil / mist to escape in one place, the breather valve(s). \\ Ultimately it breaks down to whether your breather valve(s) can handle pressure changes fast enough. | - Check for oil seepage around gaskets. \\ The crankcase should only allow oil / mist to escape in one place, the breather valve(s). \\ Ultimately it breaks down to whether your breather valve(s) can handle pressure changes fast enough. | ||
| * Pushrod tube gaskets / O-rings seem to be the weakest joints on Ironhead Sportsters. \\ If you keep replacing them due to leaks, you might want to check the breather valve (1977-1985) or breather timing (1957-1976). | * Pushrod tube gaskets / O-rings seem to be the weakest joints on Ironhead Sportsters. \\ If you keep replacing them due to leaks, you might want to check the breather valve (1977-1985) or breather timing (1957-1976). | ||
