Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ref:body02 [2017/10/17 02:42] – [Sub-Documents] hippysmack | techtalk:ref:body51 [2024/01/10 01:53] (current) – hippysmack | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ====== Fender / Luggage Racks ====== | ====== Fender / Luggage Racks ====== | ||
| - | ===== Sub-Documents ===== | ||
| - | * . . . [[techtalk: | + | **Fender |
| - | * . . . [[techtalk: | + | |
| - | * . . . [[techtalk: | + | Bluto (of the XLForum.net) gave the following information about this fender rack:\\ |
| - | * . . . [[techtalk: | + | I made a rack that bolts up to the HD Quick-Detach Sideplates. |
| + | |||
| + | The overall dimensions are 11" long x 8-1/2" wide. | ||
| + | |||
| + | The solid vertical bars which reach down into the sideplates are 4-1/2" long\\ | ||
| + | and are made of 9/16" square stock which hardware stores don't carry\\ | ||
| + | so I ordered a foot of 9/16" keystock from Amazon for about $5 IIRC.\\ | ||
| + | HD uses 1/4-20 mounting screws so I did the same. Drilled and tapped for them. | ||
| + | |||
| + | The rest of the rack is made from 16ga ERW steel tubing\\ | ||
| + | plus some 1/8" plate for the gussets and box mounts.\\ | ||
| + | The square frame tubes are 3/4". The round crossbars are 1/ | ||
| + | |||
| + | {{:techtalk: | ||
| + | |||
| + | |||
| + | \\ | ||
| + | ===== Sub-Documents ===== | ||
| + | * . . . [[techtalk: | ||
| + | * . . . [[techtalk: | ||
| + | ====== Luggage ====== | ||
| + | Here is an FLT luggage rack bent to fit the fender bolts on a 2007 Sportster XL-50, Tourpak on top. \\ | ||
| + | {{: | ||
