Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| techtalk:ih:oil04 [2025/10/20 03:15] – [Oil Lines to the Rockers] hippysmack | techtalk:ih:oil04 [2025/10/20 03:47] (current) – [Oil Lines to the Rockers] hippysmack | ||
|---|---|---|---|
| Line 307: | Line 307: | ||
| | Rocker oil line ((photo by Ironshred of the XLFORUM https:// | | Rocker oil line ((photo by Ironshred of the XLFORUM https:// | ||
| |{{: | |{{: | ||
| + | |||
| + | There are rubber grommets on both ends of the oil lines. ((IronMick of the XLFORUM https:// | ||
| + | Some guys install two on each end, which is a wrong thing to do. \\ | ||
| + | Sometimes the rubber from an improperly installed grommet plugs the oil line. \\ | ||
| + | Before going into the gearcase (to check for low / no oil to the rocker boxes); \\ | ||
| + | Remove both oil lines, and check the rubbers on both ends of each. \\ | ||
| + | |||
| + | | Oil line sleeves. ((photos by sc72 of the XLFORUM https:// | ||
| + | |{{: | ||
| + | |||
| ====== Braided Oil Lines ====== | ====== Braided Oil Lines ====== | ||