Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
techtalk:ih:engmech09h [2021/06/28 23:32] hippysmack created |
techtalk:ih:engmech09h [2023/12/31 20:22] (current) hippysmack [Rear Mount Assembly] |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== IH: Engine Mechanicals - Sub-09H ====== | ====== IH: Engine Mechanicals - Sub-09H ====== | ||
====== Rear Mount Assembly ====== | ====== Rear Mount Assembly ====== | ||
+ | The rear mount locates the motor. All other mounts bow to the rear mount. It is the king. ((ryder rick of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/109872-71-motor-mounts/page2#post3120871)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/203556-lower-frame-rail-clearance-issues#post4557070)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/198787-finally-building#post4369721)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/130889-rolling-basket-case-saga-now-it-s-the-rear-motor-mount/page3#post3120737)) \\ | ||
+ | Always always ALWAYS install all the rear mount bolts first before tightening. \\ | ||
+ | Attaching the rear mount to the motor: \\ | ||
+ | All the bolts must pass through the mount with no binding or pulling. Shim the top 2 bolts if you have to. \\ | ||
+ | Or file the bolt holes slightly to allow the mount to sit in place naturally. \\ | ||
+ | Chase the threads with a tap if needed so you get no binding when turning a bolt in a hole by hand. \\ | ||
+ | Snug the bolts down gradually to allow the mount to shift as needed as bolts are tightened. \\ | ||
+ | Do not try to adjust the rear mount so the motor will fit in the frame. Adjust the frame instead (it is most likely the problem). | ||
+ | |||
+ | And tighten all of the rear mount bolts before installing any of the other mounts in the frame. \\ | ||
+ | If you have trouble with one of the bolts, remove the others and start that one first. \\ | ||
+ | Take your time to do it right, take the motor back out if you have to. | ||
\\ | \\ |