Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ih:oil03a [2024/01/01 18:17] – hippysmack | techtalk:ih:oil03a [2025/02/23 03:57] (current) – [Outer Separator Plate Seal] hippysmack | ||
|---|---|---|---|
| Line 149: | Line 149: | ||
| ====== Outer Separator Plate Seal ====== | ====== Outer Separator Plate Seal ====== | ||
| - | There were 2 different outer plate seals used on 77-85 oil pumps. \\ | + | There were 2 different outer plate seals used on 1977-1985 oil pumps. \\ |
| It is supposed to prevent oil from rising into the scavenge gears / engine from the feed section of the pump. \\ | It is supposed to prevent oil from rising into the scavenge gears / engine from the feed section of the pump. \\ | ||
| - | * (12036) was used on 77-82 models. | + | * (12036) was used on 1977-1982 models. |
| * Sold for use with outer separator plate (26493-75) | * Sold for use with outer separator plate (26493-75) | ||
| * This seal simply slides down the driveshaft during installation and rests against the inner plate. | * This seal simply slides down the driveshaft during installation and rests against the inner plate. | ||
| * It also covers the retainer ring. | * It also covers the retainer ring. | ||
| - | * (12036A) was used on 83-90 models. | + | * (12036A) was used on 1983-1990 models. |
| * Sold for use with outer separator plate (26493-75A) | * Sold for use with outer separator plate (26493-75A) | ||
| * It has a metal outside band with bonded rubber inside. | * It has a metal outside band with bonded rubber inside. | ||
