Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
techtalk:ref:svcproc11a [2021/08/22 18:36] hippysmack |
techtalk:ref:svcproc11a [2024/01/21 06:03] (current) hippysmack |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
| - | ====== REF: Service Procedures 11B ====== | + | ====== REF: Service Procedures 11A ====== |
| ====== Setting 1991-2003 Shift Pawl Position ====== | ====== Setting 1991-2003 Shift Pawl Position ====== | ||
| Line 32: | Line 32: | ||
| The differences in the two measurements may be the way they were measured or it may be normal wear or manufacturing tolerances that are different. \\ | The differences in the two measurements may be the way they were measured or it may be normal wear or manufacturing tolerances that are different. \\ | ||
| - | | Gap dims by LenC ((photo by LenC of the XLFORUM http://xlforum.net/forums/showthread.php?p=5854262#post5854262)) | Gap dims by Hippysmack ((photo by Hippysmack)) | | + | | Gap dims by LenC ((photo by LenC of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-drivetrain/sportster-motorcycle-transmission-clutch-primary-secondary-drive/200939-shifter-problem-in-sportsterpedia/page2#post4443259)) | Gap dims by Hippysmack ((photo by Hippysmack)) | |
| |{{:techtalk:ref:svcproc:shift_pawl_centered_position_w_.096_drill_bit_by_lenc.jpg?direct&400|}}|{{:techtalk:ref:svcproc:transmission_inspection_60_by_hippysmack.jpg?direct&400|}}| | |{{:techtalk:ref:svcproc:shift_pawl_centered_position_w_.096_drill_bit_by_lenc.jpg?direct&400|}}|{{:techtalk:ref:svcproc:transmission_inspection_60_by_hippysmack.jpg?direct&400|}}| | ||
