Differences
This shows you the differences between two versions of the page.
techtalk:ref:engmech01w [2020/10/27 00:26] hippysmack created |
techtalk:ref:engmech01w [2024/01/14 20:38] (current) hippysmack |
||
---|---|---|---|
Line 7: | Line 7: | ||
It seems aftermarket lifters have a tendency to be wide at the roller end (at the opposite pins holding the roller). \\ | It seems aftermarket lifters have a tendency to be wide at the roller end (at the opposite pins holding the roller). \\ | ||
- | Measure them before installing to be sure they won't scratch the lifter bore when turned home. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?p=5283285&highlight=lifter+pins#post5283285)) \\ | + | Measure them before installing to be sure they won't scratch the lifter bore when turned home. ((Hippysmack of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-engine-conversions/179168-my-nrhs-1250-on-a-hammer-buell-conv-crank-rods-thread/page8?highlight=lifter+pins#post3846893)) \\ |
The Fueling lifters below had this problem. \\ | The Fueling lifters below had this problem. \\ | ||
The company (when contacted) said they would replace them but with concerns of receiving the same issue with replacements, these were resized at the base. \\ | The company (when contacted) said they would replace them but with concerns of receiving the same issue with replacements, these were resized at the base. \\ |